Telephone: +34 962 117 117
Free shipping*.
Country of dispatch:
Language:
Telephone: +34 962 117 117
Free shipping*.
GRESITE SWIMMING POOL PACK PRODUCTS REQUIRED FOR A 4 X 8 m SWIMMING POOL or similar
It is recommended to do so in this order:
Scrape all the areas with mortar or non-resistant stone, sweep away all the dirt, then, with a brine, wet the stone a little and apply with a sprayer our product TECNOCLEAN PISCINAS mixed with 3 - 4 parts of water, spray in sections (keep the product applied and acting on the stone for no more than 15 or 20 minutes) then rinse with a pressure washer or pressurised water, with this we will remove all the dirt embedded in the stone. If you have loose areas or joints between the stones to be repaired, this is the moment to do it, you can use M-REJUN POOL to do it.
Empty the pool and wait 1 day, in case of dirty areas such as the waterline or limescale, spray these areas with TECNOCLEAN PISCINAS mixed with 3 - 4 parts of water (reduce the proportion of water if there is stubborn dirt), leave to act for 15 to 20 minutes and rinse with a pressure washer or pressurised water.
For a correct bonding of the M-REJUN POOL mortar, the depth of the joint must be a minimum of 2 mm, if there are areas with less depth, the existing mortar must be removed. PREPARATION OF THE MIXTURE, Pour ¾ parts of the
necessary quantity of water in a clean container, as a reference for 10 kg of product 2 - 3 litres of water, add M-REJUN POOL little by little, kneading it manually or with a low speed electric drill (400-600 rpm) equipped with a mixing disc for approximately 4 to 5 min. until a homogeneous mass without lumps similar to (Greek yoghurt) is obtained. Prepare the quantity of material to be used within the first 30 minutes.
EASY APPLICATION, a trowel or rubber scraper can be slid over the entire surface diagonally to the joints, ensuring perfect penetration and compaction of the material in the joint (for small surfaces it can be applied by hand, always with cleaning gloves, latex gloves, etc) let dry for 15 to 20 minutes and for The cleaning of the edges of the joints can be done with a clean, damp sponge or cloth before the product sets completely, finish with a dry cloth.
PERFORMANCE, In stoneware applications with a depth of about 2 mm, with 1 kg of product we can grout between 1.5 and 2 m2.
After cleaning the stone it must be left to dry 3 or 4 times for proper drying and evaporation of the moisture from the cleaning we did with plenty of water.
A- In a separate bucket dilute with 20% of water our RENOVATEC CORONA paint and apply the first coat and let it dry for a minimum of 6 hours.
B - Apply the second coat neat or with a maximum of 5% of water, do not wet the surface after application within 48-72 hours.
After this treatment your pool will be as good as new for a long time.
